Unit 1, 79 Forsyth Street
O’Connor, Western Australia 6163
ph: (08) 9314 2219
email: info@phoenixpaints.com.au

AboutContactOrderProductsDistributorsFAQLinksHome
 
Mayor Products: New Distributors Wanted
 
FLEXOSEAL is a single pack water-based durable black or beige flexible membrane which is composed of a blend of a powerful water-based bitumen and a dispersed liquid rubber compound, which have been carefully formulated to produce a coating with some unique properties. Once fully cured, the film can resist water penetration, even when submerged.

FLEXOSEAL can be used to solve many problems, including repairs to suspended verandahs (including the repair of leaks between eg. balconies and exterior walls), sealing retaining walls against penetration of moisture from the backfill, water-proofing the exterior walls of subterranean cellars, workshops, wine storage areas, etc.

COLOURS: Black, beige, plus a range of other shades.

SPECIAL FEATURES:
 
  • Gives off no fumes
  • Quick development of adhesion
  • Water wash up (no solvents)
  • Easy to roll on or brush
  • Goes over any clean dry surface
  • Wide range of colours
  • Early water resistance
  • No toxic fumes or solvents
  • Can be recoated at any time if required
  • Non toxic in the dry state

TYPICAL APPLICATIONS:
 
THE PROBLEM: Cracks in exterior wall/floor interface, allow rain to leak through into the house.
THE SOLUTION: The area is masked out with tape and painted with a thick coat of beige FLEXOSEAL. A strip of FLEXOCLOTH is cut and applied over wet surface and painted over again. (see PRODUCT INFORMATION SHEET)

Beige FLEXOSEAL being used to seal leaking window frame.
Black FLEXOSEAL used to protect concrete walls of an Indonesian tapioca waste water tank.


Badly rusted and leaking gutter primed with METALFIX and top coated with black FLEXOSEAL ( use strips of FLEXOCLOTH for any joints and seams)

A view of the tanks in series. The FLEXOSEAL protects the slightly acidic waste water from attacking the concrete.

FLEXOSEAL can also be used to seal the interiors of water tanks, and can renovate older tanks (also see METALFIX)
Access hatchway of 600,000 litre water storage tank, lined with FLEXOSEAL throughout.

View of the top area of the subterranean water storage tank, before landscaping. FLEXOCLOTH strips were used over all joints and seams.
The FLEXOSEAL can be built up over the Flexocloth base, to form a very tough, flexible, and durable membrane. The thickness of the film can be varied, but is typically in the range 2mm to 3mm. The sheet widths are from 200mm to 1.2 metres and the lengths are in a standard 10 metres

PHYSICAL PROPERTIES:
 
Pot Life: Indefinite
Specific Gravity: 1.0
Colour: Black, Beige
Pack Sizes: 1 Litre, 4 Litre, 10 Litre
Dilution: Must not be diluted
Clean up: Water
Recoating Times: Approx 4-6 hours (normal conditions, temperatures above 25°C, sunlight, low humidity)
Coverage: 2 coats of FLEXOSEAL are recommended. First coat should be applied at approximately 1m2 per litre and a second coat at 2m2 per litre


PRODUCT INFORMATION SHEET:
 


For your convenience we have provided as a download, a PRODUCT INFORMATION SHEET in Adobe Acrobat format below.

FLEXOSEAL.pdf

To view a PDF file you must have Adobe Acrobat reader. It is free, and is available below.

Download Adobe Acrobat Reader
Adobe Acrobat (4mb)

 
 
     
Copyright Phoenix Paints © 2003 Designed by DD